Frontpage Slideshow (version 2.0.0) - Copyright © 2006-2008 by JoomlaWorks
Lumecon LWP-FT Forward Throw Wall Pack

LUMECON ETD™ SYSTEM:
The Lumecon High Output LED Light engine utilizes the Lumecon ETD™ (Enhanced Thermal Dissipation) System. The ETD System Engines are thermally bonded to provide maximum thermal dissipation to the exterior of the fixture to ensure long life.  To protect the light engine panel from moisture and corrosion, the LED light engine panel is uniformly coated with a UV stabilized acrylic polymer resin that meets MIL and ASTM dielectric standards and UL and IPC standards for flammability, moisture resistance and thermal shock.

LED LIGHT COLOR / QUALITY:
The High Output LEDs come standard in 4,700K Neutral White, with 3,250K Warm White and 6,250K Cool White on the Kelvin temperature scale. All are rated for a minimum of 90,000 hours of continuous operation at ambient temperatures from -40°F (-40°C) to 149°F (+65°C).

HOUSING:
Die-cast aluminum housing and hinged front, textured architectural bronze powder coat finish over a chromate conversion coating.

LENS:
Molded prismatic borosilicate glass lens.

MOUNTING:
Cast-in template for mounting directly over a 4” recessed outlet box, or use 1/2” surface conduit.

ELECTRICAL:
Each power supply (driver ) is UL 1012 compliant, operating from a 60 HZ +/- 3 HZ AC line over a voltage ranging from 95 volts to 280 volts. Each driver is an efficient switcher with a power factor of greater than 0.91 with an input current of less than 20% Total Harmonic Distortion (THD). Fluctuations of the line voltage have no visible effect on the luminous output. Each driver includes voltage surge protec­tion to withstand high repetition noise transients while meeting emission limits as set forth by the FCC Title 47, Subpart B, Section 15. 347-480 volt 50/60 HZ driver available at an additional cost. 0-10v dimming inputs are also available.

BATTERY BACK-UP (Remote only, optional):
When normal power fails, the emergency driver, which works in conjunction with the AC LED driver, immediately switches into emergency mode, operating the LEDs for a code-compliant 90 minutes. When AC power is restored, the driver automatically returns to charging mode. This is a UL Recognized component, and meets all applicable safety standards.

SPLIT CIRCUIT EMERGENCY EGRESS (Optional):
The split-circuit wiring consists of two independent circuits of LEDs that allow for one of the circuits to be fed by a remote emergency backup power source separate from the main supply.

OCCUPANCY SENSOR (Optional):
Outdoor motion sensors provide occupancy based control of outdoor lighting. Raintight and rated for -40˚F to 130˚F, sensors perform reliably in all weather conditions. Available for on/off or dim/high functionality.

ETL Listed to UL 1598 / 8750 for Wet Locations

*Meets Buy American requirements within the ARRA

Voltage:

1 – 120v – 277v
2 – 347v – 480v



For all available options see LWP-FT Cut Sheet

Download the LWP-FT - Forward Throw Wall Pack Cut Sheet (rev.9.23.2014) (PDF Format)

Download Photometric Results in an IES File Format

 

Search

Contact Us

Lumecon, LLC.
23107 Commerce Drive

Farmington Hills, MI 48335

(248) 477-5009 Office
(248) 477-5169 Fax

General Information
info@lumecon.com
Sales Information
sales@lumecon.com

Associations

           dlc

imsa logo  ida logo 1

apwa logo

ies logo

ite logo

Copyright © 2010 Lumecon. All Rights Reserved.
Administrator | FTP Manager








RocketTheme Joomla Templates