LUMECON ETD™ SYSTEM:
The Lumecon High Output LED Light engine utilizes the Lumecon ETD™ (Enhanced Thermal Dissipation) System. The ETD System Engines are thermally bonded to provide maximum thermal dissipation to the exterior of the fixture to ensure long life. To protect the light engine panel from moisture and corrosion, the LED light engine panel is uniformly coated with a UV stabilized acrylic polymer resin that meets MIL and ASTM dielectric standards and UL and IPC standards for flammability, moisture resistance and thermal shock.
LC-LG-DL-20 = 24W
LC-LG-DL-50 = 50W
LC-LG-SH-20 = 24W
LC-LG-SH-50 = 48W
LC-LG-DL-20 = 2,203 lumens
LC-LG-DL-50 = 3,822 lumens
LC-LG-SH-20 = 2,160 lumens
LC-LG-SH-50 = 4,255 lumens
LED LIGHT COLOR / QUALITY:
The High Output LEDs come standard in 4,700K Neutral White, with 3,250K Warm White and 6,250K Cool White on the Kelvin temperature scale. All are rated for a minimum of 90,000 hours of continuous operation at ambient temperatures from -40°F (-40°C) to 149°F (+65°C).
Die cast aluminum housing, ½” coin plugs with o-rings for conduit & photocell on two sides and back, textured architectural bronze powdercoat finish over a chromate conversion coating.
Clear prismatic polycarbonate lens.
Mount directly over a recessed electrical box or use ½” surface conduit.
Each power supply (driver) is UL 1310 compliant, operating from a 60 HZ +/- 3 HZ AC line over a voltage ranging from 95 volts to 280 volts. Each driver is an efficient switcher with a power factor of 0.99 with less than 20% Total Harmonic Distortion (THD). Fluctuations of the line voltage have no visible effect on the luminous output. Each driver includes voltage surge protection to withstand high repetition noise transients while meeting emission limits as set forth by the FCC Title 47, Subpart B, Section 15. 347-480 volt 50/60 HZ driver available at an additional cost. 0-10v dimming inputs, 2.5A fuse, and 20kV surge suppressor are also available.
BATTERY BACK-UP (Remote only, optional):
When normal power fails, the emergency driver, which works in conjunction with the AC LED driver, immediately switches into emergency mode, operating the LEDs for a code-compliant 90 minutes. When AC power is restored, the driver automatically returns to charging mode. This is a UL Recognized component, and meets all applicable safety standards.
SPLIT CIRCUIT EMERGENCY EGRESS (Optional):
The split-circuit wiring consists of two independent circuits of LEDs that allow for one of the circuits to be fed by a remote emergency backup power source separate from the main supply.
OCCUPANCY SENSOR (Optional):
Outdoor motion sensors provide occupancy based control of outdoor lighting. Raintight and rated for -40˚F to 130˚F, sensors perform reliably in all weather conditions. Available for on/off or dim/high functionality.
*Meets Buy American requirements within the ARRA
For all available options see LC-SM Cut Sheet
Download the LC-LG - Large Stairwell / Passageway Light Cut Sheet (rev. 1.16.2015) (PDF format)
Download photometric results for the LC-LG (.ies format)